ASM SIPLACE(SIEMENS) Axis Tester 03002801-01

ASM SIPLACE(SIEMENS) Axis Tester 03002801-01

1. 240 x 128 pixel LCD display, black and white, backlit: The menus appear on the LCD display and the recorded position deviation signals are displayed graphically. All the relevant parameters, such as time base, measured times, amplitude scaling, signal level and cursor positions with the associated time differences appear as alphanumeric information over the graphical representation of the measured curves.

2. Dynamic function display for the BNC panel assignments on the LCD display

3. Dynamic function display for the membrane key assignments on the LCD display

4. Five membrane keys for menu control

5. Green operating display LED

ASM SIPLACE(SIEMENS) Axis Tester 03002801-01

1. Connection for ribbon cable
Connection on the axis tester: 37-pin sub-D connector
Connection on the axis controller:
– 37-pin sub-D connector for S-20/23/25/F4/F5 and HS-50 machines with A361 or A362 axis controllers
– 25-pin sub-D connector for S-15/F3, G and wafflepack changer machines with A360 axis controllers
An adapter is attached to the ribbon cable in order to connect the 25-pin axis controller.
The axis controller supplies the + 5 VDC ± 5 % and ± 15 VDC ± 5 % operating voltages to the axis tester via the 37-pin ribbon cable.

2. 9-pin sub-D connector for the CAN bus cable, e.g. for connecting CAN bus-controlled boards in the placement machine (transmission speed 128 kBaud to 1 Mbaud, impedance 120 Ohm).

3. 9-pin sub-D connector for the serial interface cable (V24), e.g. for connecting an external PC (max. transmission speed 188 kBaud).

4. Four BNC sockets, impedance 50 Ohm The sockets can be assigned as required with the following signals: Track signal A or B TTL level, max. 5 V.

ASM SIEMENS SIPLACE 00353198-02 HEAD PCB COMPLETE S25 S23M F4 side b

The complete SIPLACE axis tester, part no. 03002801-01, is supplied with the following components:

– SIPLACE Axis Tester, part no. 03000761-01
– Test cable A361 … A363 (length 150 cm), with 37-pin plug and 37-pin socket for connecting to the axis controllers of S2x, F4/F5 and HS placement machines, part no. 03002803-01
– CAN bus cable, part no. 00349679-03
– RS232 C cable, part no. 03002804-01
– Manual for axis tester, part no. 00193370-01